Download User`s Manual Version 5.2

Mediant 1000
5.5.4
Configuring the Routing Tables
The Routing Tables submenu is used to configure the gateway's IP-to-Tel and Tel-to-IP
routing tables and their associated parameters:
5.5.4.1
„
General Parameters (refer to 'General Parameters' on page 132)
„
Tel to IP Routing Table (refer to 'Tel to IP Routing Table' on page 134)
„
IP to Trunk Group Routing (refer to 'IP to Trunk Group Routing' on page 138)
„
Internal DNS Table (refer to 'Internal DNS Table' on page 140)
„
Internal SRV Table (refer to 'Internal SRV Table' on page 141)
„
Reasons for Alternative Routing (refer to 'Reasons for Alternative Routing' on page
142)
„
Release Cause Mapping (refer to 'Release Cause Mapping' on page 144)
General Parameters
The General Parameters option is used to configure the gateway's IP-to-Tel and Tel-to-IP
routing parameters.
¾ To configure the general routing parameters, take these 4 steps:
1.
Open the 'General Parameters' screen (Protocol Management menu > Routing
Tables submenu > General Parameters option).
Figure 5-21: Routing Tables - General Parameters Screen
2.
Configure the general parameters according to the table below.
3.
Click the Submit button to save your changes.
4.
To save the changes to flash memory, refer to 'Saving Configuration' on page 278.
SIP User's Manual
132
Document #: LTRT-83302