Download User`s Manual

Transcript
I N T R O D U C T I O N
T O
T H E
S O F T W A R E
T O O L S
4.3 Support
Email support is recommended. Email [email protected] for technical questions. Email
[email protected] for sales questions.
Before contacting support, you should minimally make the following checks for common
errors:
•
Make sure that the clock your design uses is running. Output the clock to a probe-able
IO pin and check it with an oscilloscope.
•
Check the pinout in your constraint file against the provided UCF files and the board
netlist on the user CD.
•
Check the .PAR report file to make sure that 100% of your IOBs used have LOC
constraints. There is never a reason to have fewer than 100% of IOs located.
•
Use the .PAD report to make sure your constraints were applied correctly. Some
situations may cause ISE to reject your constraints.
•
If you are having problems with Main Bus, make sure that only one FPGA is driving
Main Bus at a time. Make sure that “Enable USB communication” is not selected in the
USB Controller program (default). This setting can interfere with MB[32-37]
•
Make sure that the "Unused IOBs" option in the ISE settings is set to "Float." This may
be required for correct operation.
•
When using the SD daughtercard, make sure you are using the OE signals on the active
buffers.
4.4 Online Documentation
There is a public access site that can be found on the Dini Group web site at
http://www.dinigroup.com/.
DN8000K10PCIE User Guide
www.dinigroup.com
105