Download User Manual E-DriveTM - Mold

Assembly
13.
Assemble the insulation plate and locating ring.
14.
Perform E-Drive Controller Checks.
Before startup of the system, read "E-Drive Controller Operating Manual".
CAUTION
Do not swap E-Drive Controllers for different E-Drive systems without checking manual as
controller setup must match mechanical system.
14.1 C
heck MODE OF OPERATION (See E-Drive Controller Operating Manual).
• If E-Drive system is designed to have the synchro-plate bottoming at a hard stop
at close position of valve pins, E-Drive controller mode of operation should be
"EndStop Mode".
• If E-Drive system is designed to have the valve pins closing position set within a
certain range (usually +/- 0.3mm), E-Drive controller mode of operation should be
"RefPinPosition Mode".
E-Drive User Manual
Not under documentation control if printed. May be revised without notice Electronic version is available at www.moldmasters.com
5-12
Revision 05
©09-2010