Download LINK/2+ Integrated Connectivity Systems User`s Guide

Table 6-7. Typical Configuration Activities Changing Voice Processor DS-0 Channel
Parameters
Activity
Command
Example
Disconnect channel(s) to be changed at the originator end of the
channel connection.
DSC DS0
NOD 31 DSC DS0 1:8:1-1:8:10
Verify channels are disconnected.
DSP DST DS0
NOD 31 DSP DST DS0
1:8:1-1:8:10
Specify channel(s) to be changed.
DEF DS0
NOD 31 DEF DS0 1:8:1-1:8:10
Current channel parameters are
displayed.
Change parameters:
•
Press SPACE bar to advance cursor to parameter to be
changed.
SPACE bar
•
Use F key or B key to scroll to new parameter value.
F key or B key
•
Repeat above steps to change additional parameters.
•
Press RETURN key to display next line of parameters.
•
Repeat above steps to change additional parameters.
•
After all changes have been made, press RETURN key to store
parameters and exit.
RETURN key
RETURN key
Verify parameter changes.
DSP DS0
NOD 31 DEF DS0 1:8:1-1:8:10
Current channel parameters are
displayed.
If required, change parameters at other end of the channel
connection and verify parameter changes.
DEF DS0 or DEF MDS0
DSP DS0 or DSP MDS0
NOD 17 DEF DS0 1:10:1-1:10:10
NOD 17 DSP DS0 1:10:1-1:10:10
CON DS0
NOD 31 CON DS0 1:8:1-1:8:10
NOTE
See the Digital Voice and Channelized
Services Parameters chapter in the
Configuration Planning Manual for channel
parameters that must be the same at both
ends of the channel connection.
Connect noncontending channels at the originator end of the
channel connection.
Update configuration worksheets.
L2UG
6/30/94
6-25