Download LINK/2+ Integrated Connectivity Systems User`s Guide

DIAGNOSTIC COMMANDS
Supervisory port diagnostic commands are described in the following paragraphs. Commands are
in alphabetical order by command mnemonic. Related commands are discussed together.
Busy Out DS-0 (BSY) Command
The BSY command places specified DS-0 channel(s) in the busy state. The busy state is also
called a remote equipment busy out (RE). When a DSP ST DS0 command is issued, the loop
status of these channels will be displayed as RE type.
NOTE:
To place V-channel(s) on a Voice Server Module in the busy state,
refer to the RST CH command in this chapter.
Issuing the LP DS0 EQ command also places the remote end of specified DS-0 channel(s) in the
busy state. The CLR LCL command clears specified channel(s) from the busy state.
Command:
[NOD xxxx] BSY {* or n:ss:cc[-n:ss:cc]...[,n:ss:cc[-n:ss:cc]]}[{/mmm or /P}]
where: /mmm = number of minutes (1-240) after which busy out is cleared automatically
(default is 2 minutes)
/P = permanent; busy out will not be cleared automatically
Center Phasor (CEN PHS) Command
The CEN PHS command optimizes the phasor(s) of the specified Voice Processor DS-0
channel(s) to reduce timing errors.
Command:
[NOD xxxx] CEN PHS {* or n:ss:cc[-n:ss:cc]...[,n:ss:cc[-n:ss:cc]]}
Clear Bypass Channel Loop (CLR BP LP) Command
See "Loop Bypass Channel and Clear Bypass Channel Loop (LP BP, CLR BP LP) Commands"
paragraph.
Clear Bypass Phasor (CLR BP PH) Command
The CLR BP PH command centers both channel phasors of specified bypass channel(s).
Command:
[NOD xxxx] CLR BP PH {* or ccc[-ccc]...[,ccc[-ccc]]
or 1:ss:ccc[-1:ss:ccc]...[,1:ss:ccc[-1:ss:ccc]]}
L2UG
6/30/94
7-9