Download C: Communication Protocol - Home Page
Transcript
6 : S O F T W A R E S E T U P A N D P R O G R A M M I N G 6.8 Programming Examples The following examples are based on an actuator with a stroke length longer than 75 inches using English units with setup parameters specified and entered beforehand. The controller will home backward first and move forward to an absolute position of 70.050-in. Five 10inch incremental moves will then be made in the backward direction. Set output 4 HIGH for 50 ms then LOW when motion completes. A. Program an example from keypad 1. Go to ‘EDIT’ then ‘PROGRAM’ menu. 2. Press the right arrow key once to select program #01 and press the ‘ENTER’ key. 3. Press the left arrow key 9 times to display the ‘HOME’ command at line #000 and press ‘ENTER’ 4. The home menu is displayed. Leave the default setting to home the carrier away from brake and press ‘ENTER’ to continue. 5. Press the down arrow key once to select line #001 and press the right arrow key 11 times to display ‘SET SPEED’ command and press the ’ENTER’ key. 6. Use the arrow keys to set the speed at 0071 in/s. Press the ‘ENTER’ key. Press up arrow key to increase value & left arrow key to change increment. 7. Press the down arrow key once to select line #002 and press the right arrow key 12 times to display ‘SET ACCEL. TIME’ command and press ‘ENTER’ key. 8. Use the arrow keys to set the acceleration time at 0250 ms and press the ’ENTER’ key. 9. Press the down the arrow key once to select line #003 and press the right arrow key 13 times to display the ‘SET DECEL. TIME’ command and press the ’ENTER’ key. 10. Use the arrow keys to set the speed at 0250 ms and press the ‘ENTER’ key. 11. Press the down arrow key once to select line #004. Press the right arrow key twice to display ‘FEED TO POSITION’ command and press the ’ENTER’ key. 12. The feed to position screen is displayed. Use the arrow keys to set the integer value to +70. 13. Press the right arrow key to switch to the decimal field. Use the up or down arrow key to set the value to +0070.050 and press ‘ENTER’ to confirm the setting. 14. Press the down arrow key once to select line #005 and 6-30