Download C: Communication Protocol - Home Page

Transcript
6 : S O F T W A R E
S E T U P
A N D
P R O G R A M M I N G
6.8 Programming Examples
The following examples are based on an actuator with a stroke length
longer than 75 inches using English units with setup parameters
specified and entered beforehand. The controller will home backward
first and move forward to an absolute position of 70.050-in. Five 10inch incremental moves will then be made in the backward direction.
Set output 4 HIGH for 50 ms then LOW when motion completes.
A. Program an example from keypad
1. Go to ‘EDIT’ then ‘PROGRAM’ menu.
2. Press the right arrow key once to select program #01 and
press the ‘ENTER’ key.
3. Press the left arrow key 9 times to display the ‘HOME’
command at line #000 and press ‘ENTER’
4. The home menu is displayed. Leave the default setting
to home the carrier away from brake and press ‘ENTER’
to continue.
5. Press the down arrow key once to select line #001 and
press the right arrow key 11 times to display ‘SET
SPEED’ command and press the ’ENTER’ key.
6. Use the arrow keys to set the speed at 0071 in/s. Press
the ‘ENTER’ key. Press up arrow key to increase value &
left arrow key to change increment.
7. Press the down arrow key once to select line #002 and
press the right arrow key 12 times to display ‘SET
ACCEL. TIME’ command and press ‘ENTER’ key.
8. Use the arrow keys to set the acceleration time at 0250
ms and press the ’ENTER’ key.
9. Press the down the arrow key once to select line #003
and press the right arrow key 13 times to display the
‘SET DECEL. TIME’ command and press the ’ENTER’
key.
10. Use the arrow keys to set the speed at 0250 ms and press
the ‘ENTER’ key.
11. Press the down arrow key once to select line #004. Press
the right arrow key twice to display ‘FEED TO
POSITION’ command and press the ’ENTER’ key.
12. The feed to position screen is displayed. Use the arrow
keys to set the integer value to +70.
13. Press the right arrow key to switch to the decimal field.
Use the up or down arrow key to set the value to
+0070.050 and press ‘ENTER’ to confirm the setting.
14. Press the down arrow key once to select line #005 and
6-30