Download Manual - Cloudfront.net

Omega 2
STAGE SCREEN
SETTING BLANK CHANNELS
SETUP
Version 1.22
SYSTEM
1> Return to main menu
2> Set channels to blank
3> Display name and link in TRACK . . . . . . . .
4> Levels shown in hex . . . . . . . . . . . . . . . . .
5> Recording in fast mode . . . . . . . . . . . . . .
6> Goto Cue aborts all fades . . . . . . . . . . . . .
7> Flash lower intensity . . . . . . . . . . . . . . . . .
8> Flash upper intensity . . . . . . . . . . . . . . . . .
9> Flashing rate . . . . . . . . . . . . . . . . . . . . . .
10> Number of dimmers . . . . . . . . . . . . . . . .
11> Number of channels . . . . . . . . . . . . . . . . .
12> Title in Stage Screen . . . . . . . . . . . .
13> Time for Go to Cues . . . . . . . . . . . . . . . .
14> Total units . . . . . . . . . . . . . . . . . . . . . .
Grandmaster FL
9:01:00
If the lighting plot is complete and all lighting fixtures are hung and
focused, the screen can be customized to only display green channels
where the fixtures are plugged and focused. This feature allows all
channels not involved in the plot to be de-emphasized by turning the
channel color to a gray (inactive) number.
To customize the screen, follow the steps below. All keystrokes are
set from the keypads on the Omega 2 Control Console.
Yes
No
Yes
Yes
10
80
1
512
60
Omega 2
0
265
TO SET THE CHANNELS TO BLANK:
Press
The cursor will be positioned on the System menu.
Enter:
Press
〉
The System menu will be displayed.
Press
The cursor will be positioned on Set Channels
to Blank.
Press
The Command Line will prompt 'Are You Sure?'
Press
again. The Blank Channels screen will appear.
BLANK CHANNELS
Grandmaster FL
ADD A CHANNEL NUMBER TO THE BLANK CHANNELS LIST:
Press
9:01:00
Chn
5
The number 5 appears on the Command Line.
Press
The number 5 now appears on the display screen.
Numbers can only be entered one channel at a time. The channel
number will still be visible on the Stage Screen, but will be
displayed in gray.
TO DELETE A CHANNEL NUMBER FROM THE BLANK
CHANNELS LIST:
Press
Enter:
Insert or
delete:
〉 INSERT 5
then press the channel number. The number appears on
the Command Line.
Press
The channel number is removed from the display
screen.
Numbers can only be removed one channel at a time.
WHEN COMPLETE, RETURN TO THE STAGE SCREEN:
Press
The Stage Screen will appear on the monitor.
35