Download DTHC IV -SETUP/INSTALL MANUAL

TABLE OF CONTENTS (cont.)
C. Making Connections to your Plasma Cutter
1. Connecting using Universal Connection Kit
2. Making Connections to Plasma
a. Finding the Correct Connections
b. Firing to Torch
c. Testing/Troubleshooting RAV-01
d. Hypertherm 1000/1250/1150 Connection Points
e. Connection to Hypertherm 45
3. Making Connections via External Connections
a. Thermal Dynamics
1. CPC Pinout
2. Automation Interface PC Board
3. A Series Pin Outs
b. Hypertherm
1. CPC Pinout 45/65/85/105/125
2. Divider Switch Settings
58-67
VI. Setting Up and Plasma Cutting with DTHCIV
A. Setting Up the Z Axis for Automatic Touchoff
1. Modifying SheetCam Post for Switch Offset and Ref Difference
B. Z Motor Tuning for Best Performance
C. DTHC Screen: Buttons and DRO Functions
1. Base DTHC Screen Elements
2. TAB Fly-out on DTHC Screens
3. DCP Option
a. Indicators
b. Cut Current Troubleshooting
D. Cut Profiles Screens
1. Define Terms
2. Adding Profiles
E. Final Testing
1. Startup Test - Manual Cut
2. Using SheetCam to Generate Code
VII. Addendums
A. Adding Digital Current Probe
B. Grounding Practices
C. Adding HYT Connect Rs485 for Hyperterm
D. Troubleshooting DTHCIV Problems
E. Adding FT-01 Feather Touch Ohmic Sensor
CandCNC
Page: 3