Download SD17060E - Advanced Micro Controls Inc

Transcript
ABOUT THIS MANUAL
Read this chapter to learn how to navigate through this manual and familiarize
yourself with the conventions used in it. The last section of this chapter highlights the manual’s remaining chapters and their target audience.
Audience
This manual explains the set-up, installation, and operation of AMCI’s SD17060E Stepper Motor Indexer /
Driver. It is written for the engineer responsible for incorporating the SD17060E into a design, as well as the
engineer or technician responsible for its actual installation.
Applicable Units
Most of this manual applies to all SD17060E indexer/driver units, but some of the features explained in this
manual are only available with later firmware revisions.
 Starting with firmware revision 5.6, the firmware revision was printed on the serial number tag. If you
don’t see a firmware revision number on the tag, then you have an older unit.
 The serial number is also a date code, so you can determine when the unit was released by reviewing the
serial number itself.
"D" prefix on all Drive
Serial Numbers
Digits 1&2
Month of Manufacture
Digits 3&4
Year of Manufacture
Serial Number of the 1st unit
manufactured in January of 2011.
Digits 5-8
Sequential Number
within the month
Firmware 8.9 and above
Units with firmware 8.9 and above, (Serial number D04120030 and above), have all of the features listed in
this manual
Firmware 6.8 and below
Units with firmwares of 6.8 and below, (Serial number below D04120029), do not have the following features:




Store Configuration parameters to Flash memory
Store Blend Move parameters to Flash memory
Heartbeat bit in Network Input Data
In firmware 8.9 and above, the Drive Enable bit in Configuration Mode is ignored. You should enable
and disable the drive while in Command Mode. For firmware 6.8 and below, the Drive Enable bit in
Configuration Mode must be used to enable the driver.
Firmware 5.6 and below
In addition to any feature listed above, units with firmware 5.6 and below, (Serial number below D03110045)
do not have the following additional features:




Modbus/TCP communications protocol
Indexed Move
Hybrid Control
IP Address cannot be configured with the Ethernet Configurator software from AMCI. You must use a
Bootp server, such as the one supplied by Rockwell Automation.
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
7