Download SD17060E - Advanced Micro Controls Inc
Transcript
ABOUT THIS MANUAL Read this chapter to learn how to navigate through this manual and familiarize yourself with the conventions used in it. The last section of this chapter highlights the manual’s remaining chapters and their target audience. Audience This manual explains the set-up, installation, and operation of AMCI’s SD17060E Stepper Motor Indexer / Driver. It is written for the engineer responsible for incorporating the SD17060E into a design, as well as the engineer or technician responsible for its actual installation. Applicable Units Most of this manual applies to all SD17060E indexer/driver units, but some of the features explained in this manual are only available with later firmware revisions. Starting with firmware revision 5.6, the firmware revision was printed on the serial number tag. If you don’t see a firmware revision number on the tag, then you have an older unit. The serial number is also a date code, so you can determine when the unit was released by reviewing the serial number itself. "D" prefix on all Drive Serial Numbers Digits 1&2 Month of Manufacture Digits 3&4 Year of Manufacture Serial Number of the 1st unit manufactured in January of 2011. Digits 5-8 Sequential Number within the month Firmware 8.9 and above Units with firmware 8.9 and above, (Serial number D04120030 and above), have all of the features listed in this manual Firmware 6.8 and below Units with firmwares of 6.8 and below, (Serial number below D04120029), do not have the following features: Store Configuration parameters to Flash memory Store Blend Move parameters to Flash memory Heartbeat bit in Network Input Data In firmware 8.9 and above, the Drive Enable bit in Configuration Mode is ignored. You should enable and disable the drive while in Command Mode. For firmware 6.8 and below, the Drive Enable bit in Configuration Mode must be used to enable the driver. Firmware 5.6 and below In addition to any feature listed above, units with firmware 5.6 and below, (Serial number below D03110045) do not have the following additional features: Modbus/TCP communications protocol Indexed Move Hybrid Control IP Address cannot be configured with the Ethernet Configurator software from AMCI. You must use a Bootp server, such as the one supplied by Rockwell Automation. 20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786 Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com 7