Download 1-input User Manual

38
8
8-6
I/O AUXILIARY SETTINGS
Compensating Control Output/Analog Output
Error that occurs in control output (at linear output) or analog output can be
compensated.
1. Release the key lock if it is applied.
For details on how to release the key lock, see "6-2 Releasing the Key Lock."
2. Set controller control action to the stop mode (reset).
For details on control stop operation, see "4-1 Control Modes."
3. Set the count value.
Call up the LOCK, etc. top screen (group 8) from the basic screen by the GRP
key.
Move to the setup screen by holding down the ENT key and pressing the GRP
key for at least 3 seconds, and select the output to compensate by pressing the
SCRN and
keys. Set the count value currently displayed on the SV display
or
key, and press the ENT key to fix and register settings
with the
LOCK, etc

Key Lock , SV Limit,
Time Unit, ADV_Mode
SCRN
SCRN
LCD Display will be blank.
PV Display
Description
Displayed when Control
Output 2 is current or
voltage.



SCRN



SCRN
Displayed when Control
Output 1 is current or
voltage.


ENT + GRP


Displayed with Analog
Output 1 or 2 (optional)
respectively.

PV Display
Description
 Control Output 1 lower limit value
 Control Output 1 higher limit value
 Control Output 2 lower limit value
 Control Output 2 higher limit value
 Analog Output 1 lower limit value
 Analog Output 1 higher limit value
 Analog Output 2 lower limit value
 Analog Output 2 higher limit value
When "0" is set, settings return to factory defaults.
4.
When you have finished setting the above, press the DISP key to return to the
LOCK, etc. screen.