Download HX7 Adjustable Speed Drive Programming and

F521
F535
Pattern Run Mode Restart Command
Direct Access Number — F521
Program ⇒ Pattern Run Control Parameters ⇒ Pattern Run
Parameter Type — Selection List
Factory Default — Disabled
This parameter sets the start condition of subsequent Pattern Runs after the
initial Pattern Run has been terminated or has completed its programming.
Changeable During Run — No
Settings:
Reset
Continue
Group #1 Speed Repeat Factor
Direct Access Number — F530
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Numerical
Factory Default — 1
This parameter sets the number of times that the pattern defined in Group #1
will be run.
Changeable During Run — No
Minimum — 1
Maximum — Infinite
Group #1 Speed #1 (Pattern Run)
Direct Access Number — F531
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 1
Up to four groups of Preset Speeds may be setup and run from this screen. The
Preset Speed numbers (1 – 15) may be entered into the Speed # field to be run
for the number of times entered into the Repeat field (0 – 254) or forever by
selecting Infinite. Running multiple Preset Speeds as a group is called a
Pattern Run.
Changeable During Run — No
This parameter allows the user to run the Preset Speeds 1 – 15 as a group and
is identified as Group #1.
Skip may be selected to ignore a Preset Speed entry.
See F520 for further information on this setting.
Group #1 Speed #2
Direct Access Number — F532
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Same as #1 Group Speed #1 (see F531).
Factory Default — 2
Changeable During Run — No
Group #1 Speed #3
Direct Access Number — F533
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 3
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #1 Speed #4
Direct Access Number — F534
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 4
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #1 Speed #5
Direct Access Number — F535
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 5
Same as #1 Group Speed #1 (see F531).
134
Changeable During Run — No
HX7 ASD Programming and Operation Manual