Download HX7 Adjustable Speed Drive Programming and

F221
F221
RX Torque Reference Setpoint #2
Direct Access Number — F221
Program ⇒ Torque Setting Parameters ⇒ Setpoints ⇒ RX
Parameter Type — Numerical
Factory Default — 100.00
This parameter is used to set the gain and bias of the RX input terminal when
the RX terminal is used as the control input while operating in the Torque
Control mode.
This is accomplished by establishing an associated V/f output pattern for a
given RX input level.
Changeable During Run — Yes
Minimum — -250.00
Maximum — 250.00
Units — %
See RX Speed Reference #1 for further information on this setting.
This parameter sets RX Torque Reference Setpoint #2 and is the output torque
value that is associated with setting of RX Speed Reference #2 while operating
in the Torque control mode.
HX7 ASD Programming and Operation Manual
83