Download HX7 Adjustable Speed Drive Programming and

F536
F546
Group #1 Speed #6
Direct Access Number — F536
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 6
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #1 Speed #7
Direct Access Number — F537
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 7
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #1 Speed #8
Direct Access Number — F538
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 8
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #2 Speed Repeat Factor
Direct Access Number — F540
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 1
This parameter sets the number of times that the enabled preset speeds of
Group #2 will be run; 0 – 254 or Infinite.
Changeable During Run — No
Group #2 Speed #1
Direct Access Number — F541
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 9
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #2 Speed #2
Direct Access Number — F542
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 10
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #2 Speed #3
Direct Access Number — F543
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 11
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #2 Speed #4
Direct Access Number — F544
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 12
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #2 Speed #5
Direct Access Number — F545
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 13
Same as #1 Group Speed #1 (see F531).
Changeable During Run — No
Group #2 Speed #6
Direct Access Number — F546
Program ⇒ Pattern Run Control Parameters ⇒ Speeds
Parameter Type — Selection List
Factory Default — 14
Same as #1 Group Speed #1 (see F531).
HX7 ASD Programming and Operation Manual
Changeable During Run — No
135