Download WebCenter_12_1_CompleteDocumentation

WebCenter
Attribute
Use case
Values
ISCORRUGATED
To indicate whether the resulting
design should be corrugated.
A Restricted Set of Text type.
If this attribute is not present, the
design is understood NOT to be
corrugated.
The values in the Restricted Set must
be true and false.
1. Create the Restricted Sets needed by your attributes as listed in the table above.
See Create a Restricted Set on page 138 for details.
2. Create your attributes (the ones listed in the table above as applicable, and any other attribute
you may need to run your particular CAD standards).
Assign the relevant Restricted Sets to your attributes. See Create an Attribute on page 140 for
details.
3. Create an attribute category containing all the attributes you have just created.
4. Add a Creation View to your attribute category and click Use Grid Layout.
a) Make the BOARD attribute Required.
b) If you are using the ISSTANDARD attribute, make it Hidden.
c) Change the Visibility of your other attributes as desired.
Tip: You can add use a Label to change how your attributes appear to the user (for example,
you can show the L attribute as Length).
If you want to work with several CAD standards, you can either reuse this attribute category for more
designs, or create more attribute categories.
Create an ARD Document Template
You now need to set up an ARD document template using the attribute category you just created.
For this, you need to use an ARD document corresponding to the CAD standard in ArtiosCAD (same
default design).
1. Set up your Document Library as explained in Create Document Templates on page 104.
2. Upload your ARD file into the Document Library.
3. Link the attribute category you just created to this ARD file.
4. Point to the Document Library in:
• existing projects in which you want to create a design from a CAD standard,
• project templates that will be used to create projects with designs from CAD standards.
See Create Document Templates on page 104 for details.
Run a Standard in an Existing Project
To create a design from a CAD standard in an existing project:
1. If your project isn't already linked to the Document Library:
a) In the Project Details page, click Configure then Document Templates.
b) Select Template, then select your document library in the list.
99
3