Download Xilinx Command Line Tools User Guide

Chapter 17: PROMGen
PROMGen Options
This section describes the options that are available for the PROMGen command.
•
-b (Disable Bit Swapping HEX Format Only)
•
-bd (Specify Data File)
•
-bm (Specify BMM File)
•
-bpi_dc (Serial or Parallel Daisy Chaining)
•
-c (Checksum)
•
-config_mode (Configuration Mode)
•
-d (Load Downward)
•
-data_file (Add Data Files)
•
-data_width (Specify PROM Data Width)
•
-f (Execute Commands File)
•
-i (Select Initial Version)
•
-intstyle (Integration Style)
•
-l (Disable Length Count)
•
-n (Add BIT Files)
•
-o (Output File Name)
•
-p (PROM Format)
•
-r (Load PROM File)
•
-s (PROM Size)
•
-spi (Disable Bit Swapping)
•
-t (Template File)
•
-u (Load Upward)
•
-ver (Version)
•
-w (Overwrite Existing Output File)
•
-x (Specify Xilinx PROM)
•
-z (Enable Compression)
-b (Disable Bit Swapping)
Disables bit swapping in HEX and BIN files.
By default (no -b option), bits in the HEX and BIN files are swapped compared to bits in the input BIT files. If
you use -b, the bits are not swapped. Bit swapping is described in Bit Swapping in PROM Files.
Syntax
-b
Note This option only applies if the -p option specifies a HEX file or a BIN file for PROMGen output.
-bd (Specify Data File)
This option specifies data files to be included in the output PROM file. Supported data file types are ELF and
MEM. If no file type is specified, ELF is assumed.
Syntax
-bd filename [.elf|.mem] [ start hexaddress ]
Command Line Tools User Guide
UG628 (v 11.4) December 2, 2009
www.xilinx.com
233