Download user manual

Photograph 4 Hyper Terminal delay setup
The terminal emulation program should be set up to allow a 100mS wait period after the
carriage return at the end of each line during a download, this gives the target time to
process the incoming data.
SILBUS-TX4A(G) CONFIGURATION RECORD
LOCATION
SILBUS NETWORK
CONFIGURATION CHECKSUM
CHANNEL
1
2
INPUT SIGNAL TYPE 1
ANALOGUE SILBUS ADDRESS
FAULT SILBUS ADDRESS
FAULT LEVEL (mA)
HYSTERESIS
SET POINT 1 TYPE AND LEVEL (mA)1
SET POINT 2 TYPE AND LEVEL (mA)1
SET POINT 3 TYPE AND LEVEL (mA)1
SET POINT 4 TYPE AND LEVEL (mA)1
SET POINT 5 TYPE AND LEVEL (mA)1
ANALOGUE TRANSMISSION TYPE
FASTLINK MARKER SILBUS ADDRESS
3
4
NOTE 1 – CURRENT INPUTS AND SET POINTS NOT AVAILABLE IN SILBUS-TX4AG
Table 2 SILBUS-TX4A Configuration record
4 CHANNEL ANALOGUE TRANSMITTER
TYPE SILBUS-TX4A(G) USER'S MANUAL
22 OF 28
120-188-12
Is s u e : 0 4