Download OMRON Ethernet Communication Server

Klinkmann Automation OMRONETH Communication Server
1
OMRON Ethernet
Communication Server
Overview
The Omron Ethernet Communication Server (hereafter referred to as the “OMRONETH
Server” or “OMRONETH” or “Server”) is a Microsoft Windows NT 32-bit application
program that acts as a communication protocol Server and allows other Windows
application programs access to data from Omron PLCs over the OMRON Ethernet
network. Any Microsoft Windows program that is capable of acting as a DDE, FastDDE,
SuiteLink or OPC Client may use the OMRONETH Server.
The OMRONETH Server requires an Ethernet card and TCP/IP protocol installed on the
computer to communicate with the Ethernet network. The OMRONETH Server can
access to data from Controllers connected to the Ethernet System directly (with Ethernet
Unit installed) or from Controllers interconnected to Ethernet System through SYSMAC
NET network or SYSMAC LINK network (through PC Gateway - an OMRON Controller
which has multiple Communications Units mounted (which includes the Ethernet Unit) and
therefore that belongs to two networks and can thus function as an interface between
them). The OMRONETH Server supports the Controller Memory Areas accessible by
FINS commands.
No additions to Controller program are needed if OMRONETH Server is used in a poll
(normal) mode, i.e. the Server sends read or write FINS command to Controller and
Controller responds with corresponding response. The OMRONETH Server supports also
the possibility to receive “unsolicited” data from Controller – in this case some additions in
Controller program are needed. By setting poll interval to 0, the OMRONETH Server
“slave” mode can be established – only unsolicited data can be received from Controller
and at same time the writing of new values to Controller is still possible.
There are two different OMRONETH Server versions described in this manual:
- Server version (ordering number DR 170 10), supporting SuiteLink, FastDDE and DDE
protocols; this version hereafter is referred to as the “Suite Link & DDE” version.
- Server version (ordering number DR 170 11), supporting OPC and DDE protocols; this
version hereafter is referred to as the “OPC & DDE” version;
The separate installation package is supplied for each version of the Server. In all cases
the name of Server executable file is OMRONETH.EXE. All further information in this
manual is same for all versions of the Server, with the exception of few points where
communication protocol specific features are explained.
OMRONETH Communication Server Ver 2.x User Manual Rev 1.12
1701XM112