1
Download 2 kW 3-phase motor control STEVAL
Transcript
UM1036 5 Description of jumpers, test pins, and connectors Description of jumpers, test pins, and connectors Table 6, 7, and 8 give a detailed description of the jumpers, test pins, and the pinout of the connectors used. Table 6. Jumper description Jumper Selection Description A position VDD = 3.3 V B position VDD = 5 V A position Software brake applied B position Disabling of OCP Present Supplying of MCU unit with VDD Not present MCU is supplied separately Present Tachometer connected Not present Hall or encoder connected Present Hall or encoder connected Not present Tachometer connected A position A position - VDD for Hall / encoder B position B position - +5 V for Hall / encoder Present Any single-shunt configuration Not present Any three-shunt configuration Present Any single-shunt configuration Not present Any three-shunt configuration Present Any three-shunt configuration Not present Any single-shunt configuration Present Any three-shunt configuration Not present Any single-shunt configuration Present Gain for any FOC Not present Gain for six-step control Present Gain for any FOC Not present Gain for six-step control Present Gain for any FOC Not present Gain for six-step control Present Gain for any FOC Not present Gain for six-step control Present Voltage doubler applied (max. 145 VAC) Not present Voltage doubler disabled W1 W2 W3 W4 W5 W6 W7 W8 W9 W10 W11 W12 W13 W14 W15 DocID18293 Rev 2 29/47 47
