Download 5 Carbon Emission Model Development

Transcript
7.2.2 Real-world Case 2, a titanium part from aerospace industry
The part selected for real-world case study 2 is a complex double side hollow
component which is typical in aircraft frame products. The machining buy –to-fly
ratio is 5. The geometry of this part is shown in Figures 7.11 and 7.12.
The material of this part is titanium alloy Ti-6Al-4V. Due to its light weight and
excellent mechanical properties, this kind of titanium alloy is getting increasingly
applied in aircraft frame structure. However, the price of titanium alloy is
expensive, and the machining rate for Ti-6Al-4V is much lower than aluminium
and steel due to its poor cutting performance. This means when manufacturing
high buy-to-fly ratio titanium parts by machining, the manufacturing time may
becomes very long and the raw material cost can also gets huge. The specific
product cost of WAAM and milling under this condition will be analysed in the
following case study.
Figure 7.11: 3D model for real-world case study 2
73