Download 5 Carbon Emission Model Development
Transcript
7.2.2 Real-world Case 2, a titanium part from aerospace industry The part selected for real-world case study 2 is a complex double side hollow component which is typical in aircraft frame products. The machining buy –to-fly ratio is 5. The geometry of this part is shown in Figures 7.11 and 7.12. The material of this part is titanium alloy Ti-6Al-4V. Due to its light weight and excellent mechanical properties, this kind of titanium alloy is getting increasingly applied in aircraft frame structure. However, the price of titanium alloy is expensive, and the machining rate for Ti-6Al-4V is much lower than aluminium and steel due to its poor cutting performance. This means when manufacturing high buy-to-fly ratio titanium parts by machining, the manufacturing time may becomes very long and the raw material cost can also gets huge. The specific product cost of WAAM and milling under this condition will be analysed in the following case study. Figure 7.11: 3D model for real-world case study 2 73