Download English - Fiery Help documents

Transcript
FOOTER
134
3 Select a control strip or media wedge.
Make sure that you select a control strip that is compatible with your measuring device.
4 Apply color management to the control strip (optional).
If color management is applied, the color patches are compressed into the color gamut of the
selected reference profile. Select “Print with color management” to check the accuracy of the
media profile.
If color management is not applied, the control strip is printed using the full color gamut of
the printer. Clear “Print with color management” to check the color accuracy of two printers.
5 Select the control strip for the nesting sheet (optional).
By default, control strips are printed for each page.
For nestings, you can print the control strip for each page, or just once for the whole nesting.
By selecting two control strips, you can select one control strip for the nested pages and one
control strip for the nesting sheet.
Nesting footer
1
2
Page footer
Sheet footer
1
2
Dynamic wedges can be created only for pages.
6 Repeat the above steps for control strip 2 (optional).
Some printers with an embedded measuring device can measure only one control strip per
job.
7 Save your changes.