1
Download 1. - DynaSCAPE
Transcript
Inserting and Editing Text Did You Know... If you have multiple lines of individual text to place on a drawing, enter it in the modifier as individual lines by using [Enter] after each line. Use the Multi option on the panel instead of Apply and you can place each line of text individually on the drawing. Insert Text Along a Flowing Line This tool allows you to insert text so that it follows along a path (existing line or polyline) on the drawing. An ‘offset’ distance can be set which is the distance away from the path to which the text will be placed. Only one line of text can be entered at any time. To use this tool: 1. Click on the tool (shown above) to open the modifier 2. In general the text width and height as well as all other settings will be left at the defaults so that all text will be the same on the drawing 3. Select a new font, if required 4. Enter the required text into the box at the bottom of the panel. 5. Click on the Apply button 6. Click the path (line or polyline) which the text will follow ‐ the line will hi‐ light blue Right‐click to end the selection process 7. Click where you want the text to be placed (the ‘start’ point) ‐ the text will be placed on the line 9.11
