Download CSD5 Servo Drive

Transcript
Parameter Group
B-69
• Errors are serious abnormalities that do not allow motor control. The
Error display alternates between a three-digit error code and a six-digit
text message.
Table C
Overtravel Display
Possible Cause
Action/Soluction
A Positive Overtravel condition
is detected.
Apply motion in a negative direction to
back
off limit.
A Negative Overtravel condition
is detected.
Apply motion in a positive direction
to back off limit.
Possible Cause
Action/Solution
The Q Type Absolute Encoder is
rotated forward or reverse over
32768 revolutions.
Reset the absolute encoder.
3.2V or less output from encoder
battery or external power supply.
Replace battery or verify external
power supply. 1
Control power is applied to the
drive while the motor is in
motion.
After verifying motor has stopped,
recycle control power.
Improper setting of analog
current scale.
Verify scaling parameter corresponds
to analog signal range.
System cannot meet motion
profile.
• Verify velocity loop tuning.
Incorrect current limit settings.
Verify current limits do not restrict
current to less than system
capabilities.
Improper setting of analog
velocity scale.
Verify scaling parameter corresponds
to analog signal range.
System cannot meet motion
profile.
• Verify position loop tuning.
Positive Overtravel
Negative Overtravel
Table D
Warning Display
Absolute Encoder Counter
Overflow
Absolute Encoder Battery
Power Up Overspeed
Over Current Command
Over Speed Command
69
• Verify system sizing.
• Verify system sizing.
CSD5 Servo Drive