Download USER MANUAL
Transcript
C COLOUR CORRECTOR There are two types of colour correction/adjustment in the SD1512. Correction/adjustment may be applied by source or by bus. Source Colour Correction applies the adjustment to a source regardless of which bus it is selected on. Bus Colour Effects applies the adjustment to a whole bus so that any source selected on that bus receives the same adjustment. Note The Source Colour Correction and Bus Colour Effects menus require that Option Card /O is fitted. Source Colour Correction The menus are accessed by pressing the COLOR CORR button in the menu group. Colour correction may be applied as lift and/or gain, in RGB and/or YPbPr, and as gamma adjustment and/or colour bleed in RGB. The right side buttons are : F1R Master On/Off switch, this must be On for the corrections to have any effect. F2R Enables the RGB part of the colour corrections, including the bleed function. F3R Enables the YPbPr part of the corrections. F6R Enters the Bleed menu. This button is only present when one of F4L to F6L is selected. The left side buttons select which component or colour is to receive correction : F1L Selects the Y component of YPbPr. F2L Selects the Pb component of YPbPr. F3L Selects the Pr component of YPbPr. F4L Selects the Red channel of RGB. F5L Selects the Green channel of RGB. F6L Selects the Blue channel of RGB. The graphs for the YPbPr adjustments (lift & gain) have two scales. One, in white from 0% to 100%, for the Y component and the other, in green from -100% to +100% for the Pb and Pr components. S&W Production & Post Production SD1512 User Manual - Issue 9, Rev 1 Page - C 15