Download SILVERMAX COMMANDS

Initialization Commands
MAXIMUM TEMPERATURE TRIP (MTT)
Description:
Sets the temperature at which SilverMax will shut down the motor. This is used to prevent internal
over-heating of the motor electronics. The value is entered in degrees Celsius integer units. (Example
“70” for 70 degrees Celsius). The maximum temperature error condition is OR-ed with the motor
driver over temperature condition. Either active will cause an Over Temperature status condition in
the Internal Status Word. The temperature can be read using the ANALOG READ INPUT
command.
Command Info:
Command
Name
Maximum
Temperature
Trip
(MTT)
Command
Type
Program
(Class “D”)
Example:
Command
Code
(Hex)
214
(0xD6)
Parameter Range
(Hex)
<Temperature>
Temperature in
°C
0 = Don’t Check
1 to 70
(1 to 0x46)
[2 Words]
QuickControl Example:
Set Motor to give an error at 70
degrees C
@16 214 70 (CR)
SilverMax Response:
ACK only
Response Example:
* 10 (CR)
SilverMax Command Reference
Command
Parameters
Page 62