Download S12(X) Debugger Manual - Freescale Semiconductor

Transcript
Synchronized Debugging through DA-C IDE
Debugger Interface
Figure 9.9 DA-C Maker Settings
Debugger Interface
DA-C v3.5 currently integrates a Debugging support Application Programming Interface
(DAPI). This interface enables the DA-C to exchange messages with the Debugger. This
shows that it is possible to set or delete breakpoints from within DA-C (in an editor,
flowchart, graph, browser) and to execute other debugger operations. DA-C follows the
Debugger in its operation, since it is always in the same file and on the same line as the
debugger. Thus, usability of both the DA-C and Debugger increases. Make the following
configurations to ensure efficient use of this Debugger Interface:
• Install communication DLL
• Configure Debugger properties
• Configure the Debugger project file
S12(X) Debugger Manual
261