Download S12(X) Debugger Manual - Freescale Semiconductor
Transcript
Synchronized Debugging through DA-C IDE Debugger Interface Figure 9.9 DA-C Maker Settings Debugger Interface DA-C v3.5 currently integrates a Debugging support Application Programming Interface (DAPI). This interface enables the DA-C to exchange messages with the Debugger. This shows that it is possible to set or delete breakpoints from within DA-C (in an editor, flowchart, graph, browser) and to execute other debugger operations. DA-C follows the Debugger in its operation, since it is always in the same file and on the same line as the debugger. Thus, usability of both the DA-C and Debugger increases. Make the following configurations to ensure efficient use of this Debugger Interface: • Install communication DLL • Configure Debugger properties • Configure the Debugger project file S12(X) Debugger Manual 261
Related documents
HC(S)12(X) Debugger.book
Freescale Semiconductor Microcontrollers User's Manual
Connection - Freescale Semiconductor
Cambridge GPS/NAV Flight Recorder v5.1
Datasheet - Freescale Semiconductor
User`s Guide
ICD-12 Target Interface
Sensorless BLDC Motor Control Using S12G240 Based on HVAC
GDI Target Interface
MON08 Target Interface Manual
MC9S12G128 Controller Board User Guide
Samsung 320MP Flat Panel Television User Manual