Download Servicing the Print Module

3
06/04 Rev. 3.00-02
SERVICE MANUAL
TTK
Servicing the Print Module
Dismantling the print
module
1
It is relatively simple to remove the cast plate
together with the components mounted on it.
Proceed as described below:
2
Tools
- Allan keys 2 mm, 2.5 mm and 3 mm
Disassembly/assembly
1. Remove the front and rear hoods.
2. Remove the front left and bottom right
housing.
P Instructions for removing the housing
parts can be found in the section
"Housing" in the chapter "Service /
General Information".
3. Pull the ribbon disc (1) off the ribbon rollup mandrel. Unscrew the Allan key
screw (2) first.
4. Detach all the cables which are
connected to the print module.
5. Remove the fastening screw (3) of the
draw unit support.
3
6. Remove the five fastening screws (4) of
the cast plate.
P Continued on the next page.
4
4
4
4
4