Download PDP-503CMX
Transcript
2. In Menu Mode AUTO FUNCTION • A function to switch to this input automatically, when a signal is inputted to the input which was selected by this setting. Automatically it goes back to previous input when there is no input signal in the input. • This function works only with “INPUT1” and “INPUT4”. • For the “INPUT1”, this function works only with Composite SYNC and Separate SYNC. POWER CONTROL • To switch the settings “Normal Display”, “Linear Brightness”, and “Power Save”. 1. Normal Display : Almost the same as PDP-502 setting “ABL ON” 2. Linear Brightness : Almost the same as PDP-502 setting “ABL OFF” 3. Power Save : New function from PDP-503 A function to lower the peak brightness and lowers power consumption. • Able to set up using RS-232C command (1: PWN / 2:PWS / 3:PWL) PURECINEMA • A function to convert 480i to 480P based on 2-3 pull-down data. • There are three settings; OFF, STANDARD, and HQ. • Able to set up input signal NTSC/480i only • Able to set up using RS-232C command (PUN/PUS/PUH) DIGITAL NR • Setting up digital noise reduction. • There are four settings; OFF, LOW, MIDDLE, and HIGH. • It is effective only in the case of a VIDEO (NTSC) signal input. • Able to set up using RS-232C command (NRN/NRL/NRM/NRH) COLOR TEMP • A function that changes setting of the colors TEMP. • There are six settings: LOW (approx. –3000K), MID LOW (approx. –2000K), MIDDLE(+/- 0K), MID HIGH(approx. +1000K), HIGH(approx. +2000K) • It is effective only in the case of a VIDEO (NTSC) signal input. • Able to set up using RS-232C command (CT1/CT2/CT3/CT4/CT5) INPUT LABEL • A function to change “INPUT LABEL” of each input. • It is able to set up max. of eight letters. 5