Download Siemens Basic 100 Mobile X-Ray

Service Manual
INSTALLATION
1 INTRODUCTION
The installation procedure consists of different operations to be carried out in the order shown in
the flow chart below.
Unpacking
Electrical connection
Acceptance test
The various operations indicated are described in detail in the following paragraphs.
The installation process can only be considered completed after the TEST SHEET regarding the
acceptance tests provided with this manual has been filled in.
NOTE: the radiological system is normally pre-installed and configured in the factory according to
the specific requirements of the customer. Certain adjustments may, however, be necessary when
components are replaced.
The whole machine parameter adjustment procedure is described in detail in this manual (SECTION
4).
Section 2
Page 2 of 10
Doc. 7762