Download JPEG2000 Stand alone DVR User Guide

JPEG2000 Stand alone DVR User Guide
CHAP.1 Appearance
1-1 Front panel introduction
1.[CD-RW]
 Built-in CD-RW for CD back-up.
2.[USB Port]
 DEVICE:Connect PC for firmware upgrade.

HOST: Connect USB memory stick for backup.
3.[IR Receiver & LED Lamps]

IR Remote Controller Receiver.

DVR Status LED:
RUN- Flashes when play picture by picture through J. Shuttle.
ACTIVE- On when the J. Shuttle is ready to use.
REC- On while recording and flashes at stand-by mode, such as no motion triggered at the motion record
mode
PLAY- On while playback.
FULL- On when HDD storage is full.
NET- On when the DVR is connected remotely.
4.[1~16 Channel Button]

witch full screen among channels, 1 for Channel 1, 2 for Channel 2, and so on.
5.[MODE]

Switch among full and split screen displays.
6.[K.LOCK]

Lock the buttons on front panel.
7.[MENU]

Enter the menu and set up.
8.[Directions & ENTER]
 Directions- Navigate the menu.
-5-