Download SConfigurator

Chapter 2
Configuring the Edge Devices
5.
In the Video Quality box (two boxes are available for a -2V product), select the desired video
quality. The following preset values are available: Very Low, Low, Medium, High, and Very High.
6.
Click Save. The receives its configuration through the wireless network. The devices reboot.
7.
In the Unit Wireless Configuration window, click Close.
8.
In the SConfigurator window, click Exit.
9.
Unplug the Ethernet cable from the device, then put back the dust cap on the network (RJ-45)
connector.
10. Connect the monitor and camera to the devices; ensure that RF and video communication works
properly in your wireless system.

1.
To set the parameters for a point-to-point repeater system:
In the Unit Name boxes of the Quick Setup window, provide a meaningful name to the two
devices.
2.
In the Country box, select the country of operation of the pair of devices. Assign the proper
country to comply to the DFS/TPC regulations, if applicable, to respect the maximum EIRP, and to
use the proper set of frequency channels.
3.
In the Repeater Mode box, select Enabled.
4.
In the Passkey box, enter two different passkeys, one per wireless cell. These user-supplied
passkeys are case sensitive and must have exactly 16 characters.
5.
In the Video Quality box (two boxes are available for a -2V product), select the desired video
quality.
6.
Click Save. As soon as these settings are saved, the devices are not communicating anymore,
since they have different wireless passkeys. The RF and video communication will be reestablished after the repeater is fully configured. The receives its configuration through the
wireless network. The devices reboot.
7.
In the Unit Wireless Configuration window, click Close.
8.
In the SConfigurator window, click Exit.
9.
Unplug the Ethernet cable from the device, then put back the dust cap on the network (RJ-45)
connector.
10. Configure the two S4300 devices making up the repeater. For the procedure, refer to the Verint
S4300-RP Installation Guide.
11. Connect the monitor and camera to the devices; ensure that RF and video communication works
properly in your wireless system.
Verint Video Intelligence Solutions
www.verint.com/video_solutions
50