Download SConfigurator

Performing a Batch Network Configuration
Performing a Batch Network
Configuration
You can configure the IP network and SNMP parameters of a batch of devices belonging to the same
subnet in a single operation. Two methods are available to set the IP addresses: DHCP or manual. For
more details on DHCP, see Appendix A: DHCP Support and APIPA.

1.
59
To perform a batch network configuration:
In the Units box, hold down either the Ctrl (non-contiguous selection) or Shift (contiguous
selection) key while selecting the devices to be configured.
2.
Right-click in the selection, then select Batch Network Configuration from the contextual menu.
The Batch Network Configuration window appears.
3.
To assign IP addresses with a DHCP server, check Use DHCP. The next four boxes become greyed
out.
4.
Enter the network information as required. In manual mode, you do not have to enter the ending
IP address since it is automatically assigned according to the number of devices to configure: The
address of each device is incremented by one.
Verint Video Intelligence Solutions
www.verint.com/video_solutions