Download NetBiter Serial Server User Manual

Transcript
NetBiter® Serial Server
SIM-4186-001
Revision 1.40
2.2
Installing the Windows Driver (Serial/IP)
To be able to use the NetBiter Serial Server you need to install the Serial/IP driver on a PC. For installation
instructions, see the “Serial/IP Quick Start” available at http://www.intellicom.se/support.
2.3
Configuring the Serial Server
2.3.1
Log in
Open a web browser (Internet Explorer for example) and enter the IP address you have set on the NetBiter
unit with the NetBiter Config utility. For example, if you entered the address 10.10.10.83 then you should
enter the text below in the address field of the browser and press enter:
http://10.10.10.83
Now you should see the login screen:
To be able to configure the serial server you should enter “admin” in the user-name box. The default
password is “admin”. You can later change the default password to something else. This will be described in
the section “Admin” below.
If you have problems to log in and you are sure that your password is correct, make sure that Caps Lock is
not enabled on your keyboard.
IntelliCom Innovation AB
Page 14 (20)