Download InBalance User Guide

Wonderware Finland InBalance Module
69
values. Global parameter values can be configured by selecting the menu command
“Global parameters”. The following dialog box with tabs “Temperature” and “Molar mass”
will be displayed:
The parameter “Hydraulic resistance” is common for all streams.
Adjusting location of elements
The connection (endpoint of a stream) can be adjusted/changed by clicking on stream
name, selecting end point and dragging it to new location. The stream name location can
be changed by clicking on it and dragging to any location. The resizing of nodes and
stream names can be done by selecting the element and dragging any corner of the
element:
InBalance Ver 1.x User Manual Rev 1.4
PR0016xm14