Download CKM Onboard Interface Programming Guide and User Manual

Safety Instructions
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
•
Only Qualified Electricians should install the Lighting Control Equipment.
•
Install in accordance with National Electrical Code (NEC) or other codes that may apply.
•
Turn power OFF at circuit breakers before removing the chassis covers or when installing or wiring high
voltage components.
•
All new wiring must be fully verified before applying power.
•
Document all wiring that is terminated to relays and other components for ease of future servicing and
programming.
•
Ensure that high voltage and low voltage wiring remains separated and enters through the designated high
and low voltage areas.
•
Equipment should not be mounted in locations where it will be readily subjected to tampering by unauthorized
personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
•
Do not use this equipment for other than intended use and at the listed voltage.
•
Servicing of equipment should be performed by qualified service personnel.
SAVE THESE INSTRUCTIONS
p2