Download User's Guide VacSimHigh Vacuum System - INTEC

has a similar characteristic. Since the same parameter k is used
for all three outgassing components a value appropriate to the
main source of outgassing during bakeout should be used.
See Outgassing test schematic
Heater
The heater is intended for use with the outgassing model and
allows a temperature profile against time to be defined.
Simulation Parameters
Initial temp:
The base temperature for the profile.
Temp:
The temperature to which the profile moves, this may be
above or below the base temperature.
Rise time:
The time taken to move from Initial temp to temp
Fall time:
The time taken to revert to Initial temp.
On time:
The time spent at temp.
Timer
Two timers are provided, one simply provides a delay while the
other gives a delayed pulse.
Simulation Parameters
Delay:
The time at which the timer output goes from zero to
one.
On time:
The pulse duration for the delayed pulse timer.
38