Download MSC121x User's Guide
Transcript
SFR Overview Table 3−2. SFR Overview (continued) Name Address (Hex) MWS 8Fh Description Memory Write Select When bit 0 is clear (default), any writes to Flash memory via MOVX instructions are written to data space; otherwise, writes are directed to code space. Writing to Flash memory may be inhibited via RSL (bit 5) and PML (bit 6) in HCR0. P1 90h Port 1 Controls the byte-wide, bit-programmable input/output called Port 1. Each bit in the SFR corresponds to a pin on the actual part. Individual bits may be configured as bidirectional, CMOS output, open drain output, or input via the Data Direction SFRs for Port 1. See P1DDRL at AEh, and P1DDRH at AFh. Each pin may also be used to provide an alternate function and this may require particular values in P1 and the corresponding data direction bits. For example, P1.4 may be either a general-purpose I/O bit, an input for interrupt INT2 or an active-low Slave Select (input or output) for the SPI interface. EXIF 91h External Interrupt Flag Four bits represent interrupt flags for interrupts INT2, INT3, INT4 and INT5 that must be cleared manually by software. INT2 and INT4 are triggered by a rising edge, while INT3 and INT5 respond to a negative edge. If a bit is set in software, an interrupt will occur if it is enabled. See Extended Interrupt Enable (EIE) at E8h, and Extended Interrupt Priority (EIP) at FBh MPAGE 92h Memory Page During execution of MOVX @Ri,A or MOVX A,@Ri an 8-bit, low-order address may be presented to external off-chip data memory via pins associated with Port 0. In the MSC121x, the upper byte of a 16-bit address is placed in MPAGE. This value appears automatically on pins associated with Port 2 when the MOVX instruction is executed. CADDR 93h Configuration Address Register The MSC121x contains 128 bytes of Flash memory that may represent hardware configuration data, such as the date of manufacture or any other identification data. This memory is distinct from all other memory addressed by the MSC121x during normal execution of instructions. To access this configuration data, a 7-bit address must first be written to CADDR. See CDATA at 94h. CDATA 94h Configuration Data Register Data in the 128 bytes of Flash hardware configuration memory is accessed via this read-only register. The 7-bit address must first be written to CADDR at 093h. NOTE: The instruction reading CDATA must not be in Flash memory itself; otherwise, the data read will be invalid. Typically, instructions will be executed from the internal boot ROM, SRAM that is mapped to code space, or off-chip program memory when reading CDATA. MCON 95h Memory Configuration Bit 7 is used to identify one of two 16-bit breakpoint registers, while bit 0 determines if the external on-chip RAM is mapped to both code and data spaces or just to data space. SCON0 98h Serial Control 0 Contains six bits that determine the format of data on serial port 0 as well as two bits for transmit and receive interrupt flags. It is used in conjunction with TCON at 88h, TMOD at 89h and various timer data registers. SBUF0 99h Serial Buffer 0 When written, SFUF0 provides data for the transmitter associated with serial port 0. When read, data is provided by the receive register. Serial data is output on pin TxD0 and received on pin RxD0. 3-6