Download CM20 USER GUIDE

CM20 START-UP CHECK LIST cont.
●
On CRT select VACUUM to go to VACUUM page. Check VACUUM STATUS:
READY and IGP < 23. Press READY at bottom right of CRT to return to main page.
●
On CRT select PARAMETERS to go to PARAMETERS page. Check 160 kV is
selected. Press READY at bottom right of CRT to return to main page.
●
On CRT select MODES to MODE SELECTION page, then CONFIGURATION to go
to CONFIGURATION. Check LaB6 CATHODE is selected.
●
Press READY at bottom right of CRT to return to MODE SELECTION page, then
select DET CONF to go to DETECTOR POSITION CONFIGURATION page. Check
BF/DF selected. Then press READY at bottom right of CRT to go to MODE
SELECTION page, and select HR-TEM to return to main CRT page.
4