Download USER MANUAL - CAMBOARD Electronics

im Vertrieb von
CAMBOARD Electronics
Upgrading the VS-121HC Firmware
11. Click Run.
As each stage of the operation completes, the check-box for that stage
changes to green 1.
When the operation is complete, all four check-boxes are green and the
message Memory Verify Pass appears 2 in the status bar.
Figure 17: Atmel – Flip Window (Operation Completed)
12. Close the Atmel – Flip window.
13. Power OFF the VS-121HC.
14. If required, disconnect the null-modem adapter from the VS-121HC.
15. Press the FLASH PROG button on the front panel of the VS-121HC
outward to its original position (see Figure 1).
16. Power ON the VS-121HC.
9.2
Upgrading the Ethernet Firmware
To upgrade the VS-121HC Ethernet firmware:
• Download the file from the Internet (see section 9.2.1)
• Connect a PC to the RS-232 port (see section 9.2.2)
• Install the latest firmware (see section 9.2.3)
1 See also the blue progress indicator on the status bar
2 If an error message: “Not Finished” shows, click Run again
www.camboard.de
23
Tel. 07131 [email protected]
Fax 07131 911203