Download Installation and operating instructions

Operating mode, boiler status / Settings
report, system parameters
Operating mode
Boiler status
Boiler status
0
Standby
1
Emission test mode
2
Soft start
3
Heat demand (heating mode)
5
Heat demand with cycle block
6
Cycle block
7
Frost protection – heating
8
Soft start
11
DHW draw-off
12 DHW reheating
13 Minimum combi time
14 DHW quick start reheating
15 Cylinder mode
16 Frost protection – cylinder
17 Pump run-on – cylinder
18 Boil dry
19 dt output reduction
20 Parallel cylinder mode
21 Max. cylinder heating time exceeded
22 Sensor operating mode 2, contact closed
23 Sensor operating mode 3, contact closed
Wolf recommends you complete the settings report carefully and to keep it safe to enable a quick
solution to be found during service and in case of a full reset.
Parameter
A00
A01
A02
A03
A04
A05
A06
A07
A08
A09
A10
A11
A12
A13
60
Setting range
Room influence
1 to 20 K / K
Heat-up optimisation
0/1
Max. heat-up time
0 to 180 min
Required heat-up time
Adjusted outside temp. sensor
0 to 24 h
Room sensor matching
-5 to +5 K
External room temp. sensor
0 to 1
Pasteurisation function
0 to 8
Service message
0 to 104 weeks
Frost protection level
-20 to +10 °C
Parallel DHW operation
0/1
Room temperature-dependent
OFF / ON
summer/winter changeover
Setback stop
OFF, -39 to 0°C
Minimum DHW temp.
0 to 60 °C
Factory
setting
4K/K
0
0
3h
0K
1
0
0
+2 °C
0
ON
Individual
setting
-
-16 °C
40 °C
30 61 872_0407