Download Addonics Technologies MSCFASA User's Manual

T E C H N O L O G I E S
User Guide
Internal mSATA SSD /
CFast card Reader/Writer
(MSCFASA, MSCFA2SA)
www.addonics.com
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
Unpacking and Overview
mSATA Adapter
SATA port
4 pin floppy
power connector
Power & Drive
Activity LED
CFAST Adapter
Micro SATA DigiDrive
(MSCFASA)
18” SATA Cable
(MSCFA2SA: Qty 2)
Dual Micro SATA DigiDrive
(MSCFA2SA)
LED information
The Power & Drive Activity LED glows green to indicate power and
blinks red to indicate drive activity.
CONTACT US
www.addonics.com
Phone:
Fax:
Email:
408-573-8580
408-573-8588
http://www.addonics.com/sales/query/
Installation
1. Slide your mSATA SSD into the adapter.
2. Install the adapter and card into the mounting bracket as shown.
3. Completed assembly is suitable for mounting the same way as
a 2.5” hard disk, including connector position and mounting taps.
Hot Swapping
This unit supports hot swapping (inserting or removing drives
while the drives are running and connected to a computer).
The SATA controller on the computer must also support hot
swapping - be sure to confirm this before attempting to insert or
remove drives while the system is running.
Also be sure to practice the appropriate safe removal procedure
before proceeding. Failure to practice safe removal procedures
will result in loss or corruption of data.