Download C-570-SA

Transcript
USER'S MANUAL
(10)Adjusting S-Curve Drive
Select C-Curve Adjust Mode (an S-Curve Mode) with MODE key. Note that it is required to set
Write Data No. A0 (Drive Type) to S-Curve Drive before selecting this mode.
■Selecting the number corresponding to the INDEX to which S-Curve Drive is applied and verifying
target address
The following example shows a case where SCSPD1 for INDEX02 is set to 1400 Hz and the target
address +1269.
・When UPPER key is pressed:
・When UPPER key is released:
Select the number assigned to the INDEX
The SCSPD currently stored in a memory appears.
whose SCSPD setting needs adjustments.
Upper digits (fixed)
Lower digits (fixed)
 RS  W.M
 SEQ  S.M
 ERR  ADJ
UPPER
 

MODE

NO.
DATA
DATA
 RS  W.M
 SEQ  S.M
 ERR  ADJ
    
UPPER
MODE
  
( Not pressed)
OP1 OP2 ABS
▼ ▲ ABS
    
H/B ST/SP 

NO.
DATA
DATA
    
OP1 OP2 ABS
▼ ▲ ABS
    
H/B ST/SP 
 

When H/B key is pressed alone, the
target addressis displayed.
Auto Switching
Upper digits
Lower digits
(approx. 0.5 sec)
(approx. 1 sec)
Decrement S-Curve Data No.
Increment S-Curve Data No.
NO.
DATA
DATA
 
NO.
DATA
DATA
   
OP1 OP2 ABS
OP1 OP2 ABS
▼ ▲ ABS
    
H/B ST/SP 


Target address is displayed with H/B key alone,
■Starting and stopping S-Curve Drive
・When UPPER key is pressed:
Select the number assigned to the INDEX
to which S-Curve Drive is applied.
Upper digits (fixed)
 RS  W.M
 SEQ  S.M
 ERR  ADJ
UPPER
 

MODE

NO.
DATA
・When UPPER key is released:
Start INDEX DRIVE in an S curve.
Lower digits (fixed)
DATA
 RS  W.M
 SEQ  S.M
 ERR  ADJ
    
UPPER
MODE
  
( Not pressed)
OP1 OP2 ABS
▼ ▲ ABS
    
H/B ST/SP 

Increment S-Curve Data No.
DATA
DATA
    
OP1 OP2 ABS
▼ ▲ ABS
    
H/B ST/SP 
 
Decrement S-Curve Data No.
NO.

 
Used in combination with H/B key:
Back to original position
Used alone to start/stop INDEX DRIVE
While INDEX DRIVE is active, the current value appears.
Upper digits
Lower digits
(approx. 0.5 sec)
(approx. 1 sec)
NO.
DATA
DATA
 
OP1 OP2 ABS
NO.
DATA
DATA
   
OP1 OP2 ABS
・ST (Start) key is enabled with UPPER key turned off, whereas SP (Stop) key operates
irrespective of whether UPPER is turned on or off.
・Pressing H/B key and then ST/SP key returns the motor back to the position where it was started
in an index movement. Verify the adjustments on the S-curve by repeating a drive that moves the
motor to the target address and the one that returns it to it original position where it was in
before an index movement was activated .
- 45 -