Download C-570-SA
Transcript
USER'S MANUAL (10)Adjusting S-Curve Drive Select C-Curve Adjust Mode (an S-Curve Mode) with MODE key. Note that it is required to set Write Data No. A0 (Drive Type) to S-Curve Drive before selecting this mode. ■Selecting the number corresponding to the INDEX to which S-Curve Drive is applied and verifying target address The following example shows a case where SCSPD1 for INDEX02 is set to 1400 Hz and the target address +1269. ・When UPPER key is pressed: ・When UPPER key is released: Select the number assigned to the INDEX The SCSPD currently stored in a memory appears. whose SCSPD setting needs adjustments. Upper digits (fixed) Lower digits (fixed) RS W.M SEQ S.M ERR ADJ UPPER MODE NO. DATA DATA RS W.M SEQ S.M ERR ADJ UPPER MODE ( Not pressed) OP1 OP2 ABS ▼ ▲ ABS H/B ST/SP NO. DATA DATA OP1 OP2 ABS ▼ ▲ ABS H/B ST/SP When H/B key is pressed alone, the target addressis displayed. Auto Switching Upper digits Lower digits (approx. 0.5 sec) (approx. 1 sec) Decrement S-Curve Data No. Increment S-Curve Data No. NO. DATA DATA NO. DATA DATA OP1 OP2 ABS OP1 OP2 ABS ▼ ▲ ABS H/B ST/SP Target address is displayed with H/B key alone, ■Starting and stopping S-Curve Drive ・When UPPER key is pressed: Select the number assigned to the INDEX to which S-Curve Drive is applied. Upper digits (fixed) RS W.M SEQ S.M ERR ADJ UPPER MODE NO. DATA ・When UPPER key is released: Start INDEX DRIVE in an S curve. Lower digits (fixed) DATA RS W.M SEQ S.M ERR ADJ UPPER MODE ( Not pressed) OP1 OP2 ABS ▼ ▲ ABS H/B ST/SP Increment S-Curve Data No. DATA DATA OP1 OP2 ABS ▼ ▲ ABS H/B ST/SP Decrement S-Curve Data No. NO. Used in combination with H/B key: Back to original position Used alone to start/stop INDEX DRIVE While INDEX DRIVE is active, the current value appears. Upper digits Lower digits (approx. 0.5 sec) (approx. 1 sec) NO. DATA DATA OP1 OP2 ABS NO. DATA DATA OP1 OP2 ABS ・ST (Start) key is enabled with UPPER key turned off, whereas SP (Stop) key operates irrespective of whether UPPER is turned on or off. ・Pressing H/B key and then ST/SP key returns the motor back to the position where it was started in an index movement. Verify the adjustments on the S-curve by repeating a drive that moves the motor to the target address and the one that returns it to it original position where it was in before an index movement was activated . - 45 -