Download Bell EXPRESSVU System information

4100_Ch3_eng
6/15/05
8:34 AM
Page 3
Using The System
Using The Remote Control
ABOUT THE IR REMOTE
The IR remote uses infrared light to control the receiver and has a maximum range
of 40 feet. You must point the remote directly at the receiver, with no solid objects in
the way.
Do NOT change the address of an IR Remote. The IR Remote Control is programmed
to control the satellite receiver when packaged. Unless you have two receivers in the
same room, you should not need to change the address. If you have two receivers in the
same room and the remote is controlling both, perform the Changing the Remote
Address procedure on page 3-9 to change the address of the remote to specifically
control one satellite receiver.
Page 3-3