Download Communication for Windows
Transcript
Communication Management for SIMATIC 505 10 This chapter describes communication between the operating unit and the PLC. The communication driver for serial connection to the SIMATIC 505 PLC is used. The connection is a point-to-point connection which is operated via the internal PLC protocol NITP. Supported operating units The following operating units can be connected to the SIMATIC 505: – PC – OP37/Pro – MP270 Known restrictions An RS422 connection to the SIMATIC 575–VME is not currently supported. When the CPU 560–2120 and CPU 560–2820 series are used and the special functions CPUs 565–2120 and 565–2820 are implemented, access to the S Memory data types (special user data types) is not possible. The standard data types can be used as normal. Installation The driver for connection to the SIMATIC 505 is supplied with the configuration software and installed automatically. With ProTool, the parameters for connection to the PLC must also be set. Please refer to the corresponding chapter on connection types for information regarding which parameters are necessary on the PLC side to connect the operating unit. Program for controlling the DP driver A PLC program is necessary which controls the driver in order to connect a PROFIBUS–DP. An example program is supplied with ProTool (written in LADDER) which can be adapted for individual requirements. The example program supports linear P–addressing. The example program is located in the directory PROTOOL\PLCPROG\SIMATIC_505. Communication for Windows-based Systems User’s Manual Release 01/99 10-1