Download Communication for Windows

Transcript
Communication Management for
SIMATIC 505
10
This chapter describes communication between the operating unit and the
PLC. The communication driver for serial connection to the SIMATIC 505
PLC is used. The connection is a point-to-point connection which is operated
via the internal PLC protocol NITP.
Supported
operating units
The following operating units can be connected to the SIMATIC 505:
– PC
– OP37/Pro
– MP270
Known restrictions
An RS422 connection to the SIMATIC 575–VME is not currently supported.
When the CPU 560–2120 and CPU 560–2820 series are used and the special
functions CPUs 565–2120 and 565–2820 are implemented, access to the S
Memory data types (special user data types) is not possible. The standard
data types can be used as normal.
Installation
The driver for connection to the SIMATIC 505 is supplied with the configuration software and installed automatically. With ProTool, the parameters for
connection to the PLC must also be set. Please refer to the corresponding
chapter on connection types for information regarding which parameters are
necessary on the PLC side to connect the operating unit.
Program for
controlling the DP
driver
A PLC program is necessary which controls the driver in order to connect a
PROFIBUS–DP. An example program is supplied with ProTool (written in
LADDER) which can be adapted for individual requirements. The example
program supports linear P–addressing. The example program is located in the
directory PROTOOL\PLCPROG\SIMATIC_505.
Communication for Windows-based Systems User’s Manual
Release 01/99
10-1