1
Download Compact T1 - Black Box
Transcript
CLI Commands
set
set (router) mgcp callagent port
Use the set (router) mgcp callagent port command to initialize the UDP port (notified
entity port) to be used by MGCP to send commands to the call agent.
Note: the MGCP specification RFC2705 suggests a port number of 2727 for the call agent.
This is the default that the CMG uses to communicate with a call agent. However, many
MGCP implementations use the port 2427, making it the same as the usual MGCP port of
a gateway. If one is having trouble reaching the call agent, one should probably try
configuring the port to 2727. This command applies to the CMG Router card only.
Syntax: set {cmg_card-addr} mgcp callagent port
{port-number}
Example: set 1 mgcp callagent port 2427
The example will set the port number to be used by MGCP to access the call
agent to 2427 for the CMG card slot 1.
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{port-number}
Port number for MGCP on the call agent. Range is from 0 to 65535. Default 2727.
Compact T1 - Release 6.1
5-111
